| : |
( Þ The CLI supports both Compaq Analyze commands and Director commands. Compaq Analyze commands use the ca preface and Director commands use the desta preface.
2
H  | ; Note |
| : å If you enter the command ca without any command verb or parameters, Compaq Analyze defaults to translation. In this case, the system event log is translated and the output is sent to the screen. |
2
| ( | : |
( e The Compaq Analyze commands that support multiple syntaxes are formed using the following convention:
( ¬ ca syntax_designator command_verb
( AWhere syntax_designator indicates which syntax you are using (if it is not the default syntax) and command_verb indicates the action you want to perform. The syntax designator is not necessary if you are using the default syntax.
( Ÿ Table 2-4 provides an overview of the available ca command verbs that support multiple syntaxes.
8 ?
| ( 1( ´ The new common syntax allows abbreviations. You only need to enter the first three letters of a command verb to initiate the command. The full command verb is shown in parenthesis. s L | N
T( f The Compaq Analyze ca commands that only support one syntax are formed using the following convention:
c
r( l ca command_verb N
E
>( j Where command_verb indicates the action you want to perform. I
I
F( Table 2-5 provides an overview of the available ca command verbs that only support one syntax.A
n
8 ?
| Z |
>2
| < | O(: | s
M( @ The Director commands are formed using the following convention:
#
( o desta command_verb i c
a
2>( j Where command_verb indicates the action you want to perform. 2
s
/( v Table 2-6 describes the command verbs used with desta.
M
8 ?
| A |
<
f
4
#
v
8 c | Title PageEx | Prevrx | NextLh | onMouseOut="self.status=''; return true">Table of Contents” | Service Tools[ | Index |Z D