VAX 3271 Protocol Emulator, Version 2.5                       SSA 25.21.13-A

HARDWARE REQUIREMENTS

Processors supported:

The following table shows which combinations of VAX system, communications 
interface and communications line speed are supported configurations:

VAX System              Communications   Max. No. of       Max. Line Speed
                        Interface        Interfaces

MicroVAX:

MicroVAX I		DPV11		 1		   4800 baud

MicroVAX II		DSV11		 2 (4 lines)	   9600 baud
			DPV11		 2		   9600 baud

MicroVAX 3300		DSV11-S		 2 (4 lines)	  19200 baud#
MicroVAX 3400		DPV11-S		 2		   9600 baud
MicroVAX 3500
MicroVAX 3600
MicroVAX 3800
MicroVAX 3900

VAX:

VAX-11/725		DMF32		 1		   9600 baud

VAX-11/730		DUP11		 1		   9600 baud
			DMF32		 1		   9600 baud

VAX-11/750		DUP11		 2		   9600 baud
			DMF32		 2		   9600 baud

VAX-11/780		DUP11		 4		   9600 baud
VAX-11/785		DMF32		 4		   9600 baud

F
RO IBM is a registered trademark of IBM Corporation.
F

VAX System              Communications   Max. No. of      Max. Line Speed
                        Interface        Interfaces
VAX 8600
VAX 8650

VAX 6000-410		DMB32		 4		  19200 baud#
VAX 6000-420
VAX 6000-430
VAX 6000-440
VAX 6000-450
VAX 6000-460

VAX 6210		DMB32		 4		   9600 baud
VAX 6220
VAX 6230
VAX 6240

VAX 6310		DMB32		 4		  19200 baud#
VAX 6312
VAX 6320
VAX 6330
VAX 6333
VAX 6340
VAX 6350
VAX 6360

VAX 8200		DMB32		 2		   9600 baud
VAX 8250		DMF32*		 2		   9600 baud
			DUP11*		 1		   9600 baud

VAX 8300		DMB32		 2		   9600 baud
VAX 8350		DMF32*		 2		   9600 baud
			DUP11*		 1		   9600 baud

VAX 8500		DMB32		 4		  19200 baud#
VAX 8530
VAX 8550
VAX 8700

VAX 8800		DMB32		 4		  19200 baud#
VAX 8810
VAX 8820
VAX 8830
VAX 8840
VAX 8842
VAX 8974
VAX 8978

VAX System              Communications   Max. No. of       Max. Line Speed
                        Interface        Interfaces
VAXstation:

VAXstation II		DSV11		 1 (2 lines)	   9600 baud

VAXstation 3200		DSV11-S		 1 (2 lines)	   9600 baud
VAXstation 3500

VAXserver:

VAXserver 3300		DPV11-S		 4		   9600 baud
VAXserver 3400		DSV11-S		 2 (4 lines)	  19200 baud#
VAXserver 3500
VAXserver 3600
VAXserver 3602
VAXserver 3800
VAXserver 3900

VAXserver 6210		DMB32		 4		  19200 baud#
VAXserver 6220
VAXserver 6310
VAXserver 6320

*   Requires use of a DWBUA UNIBUS to BI-bus Adapter

#   9600 baud is the maximum supported line speed for multiple interface 
    configurations. Operation of multiple interface configurations at line 
    speeds higher than 9600 baud may result in unreliable operation.

Note that a DSV11 synchronous communications interface supports two separate 
communications lines.

Processors Not Supported:

VAX-11/782

VAXstation I, VAXstation 2000, VAXstation 3100 Series, VAXstation 3520, 
VAXstation 3540, VAXstation 8000

MicroVAX 2000, MicroVAX 3100

Processor Restrictions

Note:  An R80/RL02 configuration is required for VAX-11/730 systems.

Block Space Requirements (Block Cluster Size = 1):

Disk Space required for installation:				   1,150 blocks
								   (589K bytes)

Disk space required for use (permanent):			     750 blocks
								   (384K bytes)

These block counts refer to the disk space required on the system disk.  The 
sizes are approximate, actual sizes may vary depending on the user's system 
environment, configuration, and software options selected.

The VAX 3271 PE requires approximately 10K bytes of non-paged memory for the 
first DMF32, DMB32 or DSV11 device; 9K bytes are required for the first DUP11 
or DPV11 device.  Each subsequent DMF32, DMB32 or DSV11 device requires an 
additional 300 bytes, while an additional DUP11 or DPV11 device requires an 
additional 350 bytes.  Each terminal requires an additional 300 bytes for a 
DMF32, DMB32 or DSV11 or 350 bytes for either a DUP11 or DPV11.

When the emulator is running, further non-paged memory is allocated which is 
sufficient to accommodate the number and size of the buffers requested by the 
user.  In addition, each DMF32, DMB32 or DSV11  device uses approximately 4600 
bytes of non-paged memory for data transfer.  For all five device types, the 
VAX 3271 PE adds 24 bytes to the buffer size specified by the user.

CLUSTER ENVIRONMENT*

This layered product is fully supported when installed on any valid and 
licensed VAXcluster* configuration.  It must be installed once on each VAX, 
MicroVAX or VAXstation processor from which usage is planned.  The HARDWARE 
REQUIREMENTS sections of this product's Software Product Description and System 
Support Addendum detail any special hardware required by this product.

In order to configure some product specific attributes that must remain unique 
to each system, certain components of the product are stored in the system 
specific environment, SYS_$SPECIFIC:[SYSxxx] of the VAX, MicroVAX or VAXstation 
processor on which the installation is performed. The remaining components of 
the product, including some or all of the executable images, will be installed 
common to all accessing systems.

*   V5.x VAXcluster configurations are fully described in the VAXcluster 
    Software Product Description (29.78.xx) and include CI, Ethernet and Mixed 
    Interconnect configurations.

OPTIONAL HARDWARE

oo   VT2XX or VT3XX terminals

oo   VT100 terminals with Advanced Video Option

oo   Any of the following terminals or personal computer (with the appropriate 
    hardware and software) operating in VT100 emulation mode:

    - Rainbow 100

    - DECmate/WPS

    - PRO-325 or PRO-350 (with P/OS Operating System, Version 1.7 and 
      PRO/Communications)

The number of VT terminals (or Digital Personal Computers running in VT100 
emulation mode) supported by the 3270 Terminal Emulator utility will depend on 
application and system loading.

SOFTWARE REQUIREMENTS

Operating System

VMS Operating System V5.0 - V5.2

Layered Products

VAX Wide Area Network Device Drivers V1.1 (SPD 29.64.xx)

VMS Tailoring

For VMS V5.x systems, the following classes are required for full functionality 
of this layered product.

oo     VMS Required Saveset

oo     Programming Support

oo     System Programming Support

oo     Utilities

GROWTH CONSIDERATIONS

The minimum hardware/software requirements for any future version of this 
product may be different from the minimum requirements for the current version.

The 3270 Terminal Emulator's performance depends on system and line load, the 
IBM RO application, and the rate of data entry.  Refer to product release notes 
or your local Digital office for further information.

DISTRIBUTION MEDIA

Tape: 9-Track 1600 BPI Magtape (PE), TK50 Tape Cartridge

ORDERING INFORMATION

Software Licenses: QL-112A*-**
Software Media: QA-112A*-**
Software Documentation: QA-112AA-GZ
Software Product Services: QT-112A*-**

*   Denotes variant fields.  For additional information on available licenses, 
    services and media, refer to the appropriate price book.

The above information is valid at the time of release. Please contact your 
local Digital office for the most up-to-date information.

November 1989
BH-LY56B-TE


(R) The DIGITAL Logo is a registered trademark of Digital Equipment 
Corporation.

(T) MicroVAX, VAX, VAXstation, VAXserver and VT are trademarks of Digital 
Equipment Corporation.

