DIGITAL AV-U721J-TE Before You Install VAX ACMS Version 3.2 This package contains the VAX ACMS Version 3.2 software, installation instructions, and user documentation. Follow these steps to install VAX ACMS Version 3.2 on your VMS operating system: 1. Read the Bill of Materials enclosed in the transparent plastic envelope. Check to determine that all listed items are in your kit. If any items are missing, contact your Digital representative. 2. Make sure that you have VMS Version 5.4-1 or higher in- stalled on your system. 3. If you are planning to install the ACMS development kit, make sure that CDD/Plus Version 4.2A or higher is in- stalled on your system. 4. If you plan to use DECforms with VAX ACMS, make sure that DECforms Version 1.3 or higher is installed on your sys- tem. 5. If you plan to use LSE with VAX ACMS, make sure that LSE Version 2.3 or higher is installed on your system. 6. If you plan to use TEAMDATA with VAX ACMS, make sure that TEAMDATA Version 1.3 or higher is installed on your sys- tem. The ACMS documentation set has been significantly improved and reorganized in Version 3.2. Use the following guide- lines to organize your documentation into the correct binder sizes (if you are updating an existing documentation set, use two of your existing 2 inch binders and two of your ex- isting 21 inch binders): 2 (continued on other side) Volume 1 21 inch binder 2 Volume 2A 2 inch binder Volume 2B 2 inch binder Volume 2C 2 inch binder Volume 3 21 inch binder 2 TP Case Study21 inch binder 2 The System Support Addendum (SSA) contains a complete list of the products that are compatible with this version of VAX ACMS. The SSA is part of the Software Product Descrip- tion (SPD). © Digital Equipment Corporation. 1991. All rights reserved. 2